Using a 10MM open end wrench, remove every-other sucker tube at either side of center tube for a total of six tubes.
Thread the Sucker tube Spacers onto the threaded end of each sucker tube using a pair of pliers to gently grip the spacers at edges.
‘Do Not’ attempt to grip and thread Spacers onto sucker tubes with your bare fingers! The thin (only .017″ thick) spacers can act as a rotary knife and easily cut your fingers!
Re-install suckertubes and re-tighten them and you are ready to begin feeding troublesome stocks more effectively at higher production speeds.
Using 12MM Bearing Press.
Insert bolt thru gear as shown, making sure that bearing is perfectly centered in gear with clutch identifcation marks facing down towards bearing.
Assemble bearing press as shown and then turn press nut clockwise until new bearing/clutch is pressed completely into gear.
Kompac Parts 002.jpgNever touch by hand or use Ink Knife to scrape paper/cotton fibers from the Kompac when operating!
The ‘inward nip’ of the Kompac is very dangerous and unforgiving to fingers or tools!
Never touch the Kompac rollers when press is in operation!
Attached photo is of Ink Knife damaged Kompac Form Roller.
Seal Backing Plates hold the Kompac Seals securely inplace by spring pressure.
Compression springs press seals against form roll ends under constant pressure.
When seals are removed for cleaning or replacement steel backing plates press on ends of Form Roll.
If press is powered with seals removed the form roll will be damaged.
Attached photo shows form roll end damaged due to rubbing against steel backing plate under power.